粉末涂料 化学品

Polyester-HAA (hydroxyalkylamide) systems are the dominant outdoor-durable powder coating — TGIC-free and with excellent weathering performance. Epoxy-polyester hybrids are cost-effective for indoor applications (furniture, shelving). Pure epoxy powders give excellent chemical and corrosion resistance for pipeline and rebar coating. PVDF and polyurethane powders address demanding outdoor durability.

Flow agents — typically polymethylsiloxane (PDMS) or acrylate-based flow additives at 0.5–2% — ensure good leveling when the powder melts in the oven. The particle size of the powder resin (typically D50 of 30–60 µm) and melt viscosity of the resin system are the primary factors affecting film smoothness and orange-peel reduction.

Standard powder coatings have a particle size distribution of 10–100 µm with D50 around 35–55 µm for electrostatic spray application. Fine powders (D50 < 25 µm) are used for thin film applications (<40 µm DFT) but require careful handling to avoid dust and reduced transfer efficiency. Particle size is controlled during the grinding and classifying stage of manufacture.

Antimicrobial powder coatings incorporate silver-, copper-, or zinc-based additives at 0.5–2% to achieve efficacy per ISO 22196 / JIS Z 2801. Texture effects come from incompatible polymer microspheres or texture additives. Metallic effects use bonded aluminum or pearlescent pigments. Hammer-tone effects rely on specific flow agents that create controlled crater patterns during cure.

Standard polyester-HAA powders cure at 200°C / 10 min PMT. Epoxy hybrid powders cure at 180°C / 10–15 min — often 160°C for thermally sensitive substrates. Low-temperature cure powders (140–150°C) use modified TGIC-free polyesters or accelerated epoxy systems. UV-curable powders for heat-sensitive substrates (MDF) melt by IR at 110–120°C followed by UV crosslinking.

Common defects: orange peel (caused by fast crosslinking or poor flow control), pinholes (from outgassing of zinc-coated steel), Faraday cage effects in deep recesses, and poor cure (PMT below target). Prevention: optimize flow agents and cure profile, use degassing additives (benzoin) for zinc substrates, use tribocharging or specialized guns for complex geometries, and verify cure with MEK rub and thermocouple data on production parts.