Recubrimientos Curables por UV Productos Químicos

Urethane acrylate oligomers (UAO) provide the best balance of flexibility and hardness — aliphatic variants give UV stability for outdoor use. Epoxy acrylates cure fast and give high hardness and chemical resistance for paper and wood. Polyester acrylates are cost-effective for films and flexible substrates. Silicone acrylates add release or anti-fingerprint properties.

For surface cure, alpha-cleavage photoinitiators (Irgacure 184, 907) are standard. For pigmented systems, bis-acylphosphine oxides (BAPO, Irgacure 819) give better through-cure. Thioxanthone derivatives (DETX) are used as co-initiators for oxygen-inhibition sensitive formulations. LED-compatible photoinitiators absorbing at 365 or 395 nm are increasingly important as LED lamps replace mercury.

LED UV systems emit at narrow bands (365, 385, or 395 nm) rather than the broad spectrum of mercury lamps. They offer longer lamp life, instant on/off, no ozone emission, and lower heat output on heat-sensitive substrates. Photoinitiator selection is critical — acylphosphine oxides and novel Type II systems absorbing at 365–395 nm are required for good cure efficiency.

Standard UV coatings require 200–500 mJ/cm² total UV-A dose for full cure. Pigmented systems (whites, blacks) need higher dose due to absorption losses. Cure dose is measured by puck radiometry under the lamp; LED UV at 395 nm provides higher useful dose per watt due to better photoinitiator absorption match. Inline UV monitors track lamp output for closed-loop process control.

UV waterborne systems combine the low-VOC advantage of water with the rapid cure of UV. Challenges include water removal before UV cure (requires IR or convection drying stage), formulating photoinitiator with sufficient solubility/dispersibility in aqueous phase, and avoiding film defects from water entrapment. They are widely used on heat-sensitive substrates such as PVC flooring and pre-laminated panels.

UV coatings on plastics require adhesion promotion (silane coupling agents, chlorinated polyolefin, or surface activation by corona/flame) and flexibility tuning to accommodate substrate movement. Mono- and difunctional acrylate monomers with longer aliphatic chains provide flexibility; trifunctional and aromatic monomers raise crosslink density and hardness. Hybrid UV-thermal cure systems can also improve adhesion to ABS, PC, and PP automotive interior parts.