Recubrimientos Industriales Productos Químicos

Two-component epoxy/polyamide systems dominate heavy-duty corrosion protection. Acrylic polyol/isocyanate (2K PU) gives superior gloss retention and UV durability for OEM topcoats. Waterborne polyurethane dispersions (PUD) are increasingly used to meet VOC regulations while maintaining film hardness.

Melamine-formaldehyde (MF) resins — particularly highly methylated MF — are standard crosslinkers for thermoset acrylic and polyester baking enamels cured at 120–150°C. Blocked isocyanates are preferred for one-component PU systems that cure above 140°C without pot-life issues.

For low-energy substrates (plastics, oily metals), silicone-based wetting agents provide the lowest surface tension reduction. For metallic substrates where adhesion is critical, phosphate ester wetting agents with specific anchoring chemistry work best. We can recommend specific grades based on your substrate type.

Waterborne 2K PU combines a hydroxyl-functional acrylic dispersion with a hydrophilically modified polyisocyanate hardener. Mixing requires high shear or a static mixer to disperse the isocyanate evenly. Pot life is typically 2–4 hours. Acid catalysts and emulsifier-modified hardeners drive stable emulsification, complete cure, and freedom from CO2 bubbles caused by isocyanate-water side reaction.

Standard industrial baking enamels cure at 140–160°C for 20–30 min substrate-temperature, with peak metal temperature (PMT) of 150–180°C. Low-bake enamels (110–130°C) use modified melamine or blocked isocyanate to save energy. High-temperature schedules (180–220°C) apply to coil and OEM appliance lines. Cure completion is verified by MEK double-rub (>100), pencil hardness, and crosshatch adhesion.

Two-layer OEM industrial systems combine an epoxy primer (with zinc phosphate or zinc dust) at 50–80 µm DFT for corrosion protection with an acrylic-melamine or 2K PU topcoat (40–60 µm DFT) for UV durability and aesthetics. Adhesion is verified by salt-spray (ASTM B117 ≥1000 h), cyclic corrosion (ASTM D5894), and crosshatch + tape pull-off testing.