柔版油墨 化学品

Nitrocellulose (NC) with polyamide or polyurethane modifiers is traditional for solventborne flexo inks on films — offering excellent adhesion and gloss. Polyurethane (PU) binders alone dominate where lamination bond strength and non-blocking are critical. Acrylic-based and acrylic-styrene binders are used in waterborne flexo on corrugated and paper.

Ethanol is the dominant solvent in flexo inks — fast evaporation rate, low cost, and regulatory acceptance for food packaging. Ethyl acetate, n-propanol, and IPA are co-solvents for adjusting evaporation rate and viscosity. For polyurethane binder systems, MEK or acetone may also be used. Solvent balance is critical for drying rate and residual solvent compliance.

Waterborne flexo inks are mandated by VOC regulations for food packaging in the EU and increasingly globally. They require careful pH control (pH 8–9) and slightly slower drying than ethanol-based inks. Improvements in waterborne PU and acrylic binder technology have largely closed the performance gap, but foam control and ink stability over long print runs still require careful formulation.

Flexo pigment concentrates are dispersed at 25–50% pigment loading using bead mills or basket mills. Pigment particle size must be reduced to D90 < 1 µm for color development and printability. Polymeric dispersants with anchoring groups specific to each pigment type (basic for organic reds, acidic for phthalocyanines) ensure stable dispersions with 6+ months shelf life and minimal viscosity drift.

For low-energy substrates (LDPE, PP), wetting additives (polyether-modified silicones) and adhesion promoters (CPP-based, polyethyleneimine) are essential. Corona-treated OPP requires a 8–10 dyne/cm differential to drive wetting. Slip additives (waxes, micronized PE/PTFE) reduce friction for rub resistance. NC-only formulations include plasticizers for flexibility on flexible films, especially in cold storage.

Flexo inks operate at 18–35 seconds Zahn 2 cup viscosity (ethanol-based formulations). Pseudoplastic (shear-thinning) rheology is preferred — low viscosity at the anilox-to-plate transfer (high shear) for clean ink release, then higher viscosity on the substrate for sharp print. Polymeric thickeners and acrylic binder MW distribution are tuned to deliver this profile. Online viscometers maintain target during long press runs.