Selantes para Construção Produtos Químicos

Silicone sealants dominate high-performance glazing and structural applications for UV stability, wide service temperature (-60°C to +200°C), and long-term joint movement accommodation. Polyurethane (PU) sealants offer paintability and good adhesion to concrete, masonry, and wood. Modified silicone (SMP/SPUR) hybrids combine silicone weathering resistance with PU paintability. Acrylic latex sealants are low-cost options for interior gaps with low movement.

Joint movement capability (±% of joint width) defines the sealant's ability to accommodate thermal, seismic, or structural movement. ISO 11600 classifies sealants by movement accommodation: Class 25 (±25%), Class 12.5 (±12.5%), and Class 7.5. Structural silicone glazing (SSG) uses ISO 11600 Class 25 sealants. Joint width is designed to limit sealant elongation to within 25% of its movement capability during worst-case thermal cycling.

Ground calcium carbonate (GCC) and precipitated CaCO3 are primary extender fillers — surface-treated with stearic acid or silane for improved dispersion in silicone and PU systems. Fumed silica provides reinforcement and thixotropy. Plasticizers (diisononyl phthalate, TXIB, phthalate-free alternatives) adjust modulus and elongation. Filler loading significantly affects sealant modulus — high-modulus sealants use less filler; low-modulus formulations use higher filler content.

Silane adhesion promoters (aminosilane, epoxysilane, vinylsilane) are the primary adhesion promoters for construction sealants. Aminosilanes (APTES, AMMO) bond well to glass, concrete, and metals in silicone and PU systems. Titanate coupling agents improve adhesion to aluminum. Surface primers containing silane provide a pre-treatment layer for demanding substrates. Adhesion is validated per ISO 8339 and ASTM C794.

Structural silicone glazing sealants must pass ETAG 002/EAD 090010 qualification: tensile adhesion >0.14 MPa maintained after water immersion, UV aging, and heat aging. Structural bite calculation per EN 13022 defines minimum sealant width. Two-part silicone SSG systems allow quality control via butterfly test (mix ratio). One-part moisture-cure SSG needs controlled application conditions — minimum 35% RH for full cure of deep sections.